Samsung MM-DX7 User Manual (user Manual) (ver.1.0) (English) - Page 25

Selecting the cassette Playback Mode/Repeat A↔B /Tape Counter Function Selecting the Cassette Playback Mode Your micro component system has three cassette playback modes which enable you to listen to both sides of a cassette automatically. . Press REVERSE MODE until the appropriate symbol is displayed. • : One side of the selected cassette and then stops. • : One side of the cassette. The other side of the cassette and then stops. • : Both sides of the cassette indefinitely until you press stop. REPEAT A↔B Function Press REPEAT A↔B button. • Use this to listen to a specific section again during playback. • Set the start and end points of the section you want to repeat 3 times. • This is a useful when learning a foreign language. • The TAPE REPEAT function can be used only on sections that are longer than 7 seconds. Note • You cannot set the end point (B) within 7 seconds after setting the start point (A). • Repeat A-B Function is available for TAPE only. Tape Counter When playing cassette, a counter is displayed to enable you to take note of the counter value at the start of each track to start playback at the beginning of the track to which you wish to listen. • Before starting to record a cassette for which you wish to take note of the counter values at the beginning of each track, reset the counter by pressing and hold COUNTER RESET . 47 Timer Function • The timer enables you to switch the system on or off at specific times. • If you no longer want the system to be switched on or off automatically, you must cancel the timer. • Before setting the timer, check that the current time is correct. • For each step, you have a few seconds to set the required options. If you exceed this time, you must start again. Example: You wish to wake up to music every morning. 1 Switch the system on by pressing POWER. Press 2 TIMER/CLOCK until TIMER is displayed. 4 Set the timer switch-on time. 5 Set the timer switch-off time. a. Set the hour by pressing or button. b. Press ENTER. • The minutes flash. c. Set the minutes by pressing or button. d. Press ENTER. • OFF TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switchoff time already set; you can now set the timer switch-off time. a. Set the hour by pressing or button. b. Press ENTER. • The minutes flash. c. Set the minutes by pressing or button. d. Press ENTER. • VOL 10 is displayed, where 10 corresponds to the volume already set. 7 Press or button to select the source to be played when the system switches on. 8 Press ENTER to confirm the timer. • TAPE (cassette) : Insert a cassette tape. • TUNER (radio) : a Press ENTER. b Select a preset station by pressing Tuning or . • CD (compact disc) : Load a compact disc. • USB :Connect the USB. Note • If the timer switch on and off times are identical, the word ERROR is displayed. 3 Press the ENTER button. • ON TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch-on time already set; you can set the timer switch-on time. 6 Press or button to adjust the volume level and press ENTER. • The source to be selected is displayed. 9 Press POWER to set the system to standby mode. • is displayed to the top-right of the time, indicating that the timer has been set. • The system will switch on and off automatically at the required times. 48 MISCELLANEOUS