Samsung PN50A460S4D Quick Guide (easy Manual) (ver.1.0) (English) - Page 5

Connecting a VCR Connecting to Video 1 Unplug the cable or antenna from the back of the TV. VCR Rear Panel TV Rear Panel TV Side Panel Audio Cable (Not supplied) 2 Video Cable (Not supplied) Antenna Cable (Not supplied) ➢ When connecting a VCR, match the color of the connection terminal to the cable. 2 Connect the cable or antenna to the ANT IN terminal on the back of the VCR. 3 Connect an Antenna Cable between the ANT OUT terminal on the VCR and the ANT IN terminal on the TV. 4 Connect a Video Cable between the VIDEO OUT jack on the VCR and the AV IN 1 [Y/VIDEO] or AV IN 2 [VIDEO] jack on the TV. 5 Connect Audio cables between the AV IN 1 [R-AUDIO-L] jacks on the TV and the AUDIO OUT jacks on the VCR. 6 Press the SOURCE button on the remote control until you see the VCR signal (see "To Select the Source" on page 10). ➢ If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the right and left audio input jacks of the TV. If your VCR is stereo, you must connect two cables. ➢ Each VCR has a different back panel configuration. ➢ When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow). Connecting to S-Video VCR Rear Panel TV Rear Panel Antenna Cable (Not supplied)  2 Audio Cable (Not supplied) S-Video Cable (Not supplied) TV Side Panel 1 To begin, follow steps 1-3 in the previous section to connect the antenna or cable to your VCR and your TV. 2 Connect a S-Video cable between the [S-VIDEO] jack on the TV and the S-VIDEO OUT jack on the VCR. 3 Connect Audio cables between the AV IN 2 [R-AUDIO-L] jacks on the TV and the AUDIO OUT jacks on the VCR. 4 Press the SOURCE button on the remote control until you see the VCR signal (see "To Select the Source" on page 10). ➢ When connecting a VCR, match the color of the connection terminal to the cable. ➢ Each VCR has a different back panel configuration English - 5