Samsung SCC-B2335 Service Manual - Page 55

7. Schematic Diagrams 7-1 All block Diagram 7-2 7-2 Power Distribution Diagram 7-3 7-3 Power (Power PCB 7-4 7-4 A1 DSP (CCD PCB 7-5 7-5 CCD (CCD PCB 7-6 7-6 CDS_AGC_A/D (CCD PCB 7-7 7-7 Day_Night (CCD PCB 7-8 7-8 EEPROM (CCD PCB 7-9 7-9 H-Drive (CCD PCB 7-10 7-10 I/O (CCD PCB 7-11 7-11 IRIS Control (CCD PCB 7-12 7-12 Motor Drive (CCD PCB 7-13 7-13 Regulator (CCD PCB 7-14 7-14 Reset (CCD PCB 7-15 7-15 RS-485 (CCD PCB 7-16 7-16 UTP (CCD PCB 7-17 7-17 V-Drive (CCD PCB 7-18 7-18 Video (CCD PCB 7-19 7-19 Video Communication (CCD PCB 7-20 7-20 UTP 1/1 (REAR PCB 7-21 7-21 UTP 1/2 (REAR PCB 7-22 ● For schematic Diagram - Resistors are in ohms, 1/8W unless otherwise noted. Note Special note : Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques described under the "electrostatically sensitive (ES) devices" section of this service manual. Note : Do not use the part number shown on this drawing for ordering. The correct part number is shown in the parts list (may be slightly different or amended since this drawing was prepared). Important safety notices : Components identified with the mark have the special characteristics for safety. When replacing any of these components. Use only the same type. Samsung Electronics This Document can not be used without Samsung's authorization 7-1