Samsung SP-D400S User Manual (user Manual) (ver.1.0) (English) - Page 11
RS-232C port For service input terminals, HDMI/DVI IN Input port - lampe
View all Samsung SP-D400S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Action 1 Action 2 Action 3 Action 4 Action 5 Action 6 When the cooling fan system is not in normal operating condition. When the lamp cover protecting the lamp unit is not properly closed or the sensor system is not in normal operating condition. When temperature inside of the projector becomes too high. When the color wheel fails to operate. The lamp malfunctions after power turns off abnormally or after powering on right after turning off the projector. When the screen becomes darker If the symptom remains even after disconnecting and then reconnecting the power cord and turning the projector on again, contact your product provider or our service center. Check whether the screws at the bottom side of the projector are fastened correctly. If they are abnormally fastened, contact your product distributor or service center. Adjust the installation state of your projector by referring to the Installation Precautions section listed above. Cool down your projector sufficiently and then operate it again. If the same problem occurs continually, contact your product distributor or service center. Disconnect and reconnect the power cord and start the projector again. If the same symptom still occurs, contact your product distributor or service center. Turn the power off, wait for a sufficient amount of cooling time and then turn the power on to operate. If the same problem occurs continually, contact your product distributor or service center. Check the lamp usage time on the Information Display screen. If you need to replace the lamp, contact your product distributor or service center. This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise, which does not affect the product performance and is part of normal operation. Rear Side 1. RS-232C port (For service input terminals) 6. HDMI/DVI IN Input port