Samsung SP-H800 Owners Instructions - Page 9
Samsung SP-H800 - DLP Projector - HD 720p Manual
View all Samsung SP-H800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Indicator Information : Turned on TEMP LAMP : Blinks STANDBY : Turned off Information If you press the POWER button on the remote control or projector, the screen appears within 30 seconds. The projector is in normal operating condition. This state appears when the projector is preparing an operation after the POWER button on the projector or the remote control has been pressed. The POWER button is pressed to turn off the projector, and the cooling system is in operation to cool off inside of the projector. (Lasts for about 1 minute and 30 seconds) Refer to measure 1 below if the cooling fan inside the projector is not in normal operation condition. Refer to measure 2 below if the lamp cover protecting the lamp unit is not closed properly. Power is turned off automatically when temperature inside of the projector goes beyond the control limit. Refer to measure 3. Refer to measure 4 below if the life span of the lamp is running out or a problem with the lamp is detected. Preparation Projector and Accessories Clearing Indicator Problems Classification Measure 1 Measure 2 State Measures If the symptom remains even after disconnecting and then When the cooling fan system is not in normal operating condition. reconnecting the power cord and turning the projector on again, contact your product provider or our service center. Check the screw on the bottom side of the projector. If you When the lamp cover protecting do not find any problem, contact a dealer or service the lamp unit is not properly closed or the sensor system is not personnel near you. in normal operating condition. Adjust the position of the projector following the When temperature inside of the installation instructions of this manual and cool off the projector becomes too high. projector before restarting it. If the problem does not disappear, contact a dealer or service personnel near you. Turn the power off, wait for a sufficient amount of cooling The lamp is malfunctioning after time and then turn the power on for operations. abnormal power off or restarting right after turning off the projector. Check how long the lamp has been used on Information When brightness of the picture and contact a dealer or service personnel near you for lamp screen degrades or image replacement. deterioration is found. Measure 3 Measure 4 NOTE This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise, which does not affect the product performance. No exchange or refund for the noise concern. 9