Samsung WEP170 User Manual (user Manual) (ver.1.0) (English) - Page 6

Read the glossary, Pair to your Bluetooth phone - charger

Page 6 highlights

English WARNING: Do not attempt to charge headset with anything other than the AC adaptor provided. Using another AC adaptor may damage or destroy the headset. IMPORTANT: The red indicator light will be on while charging and will turn blue when charging is complete. Removing the charger from the headset during charging will put the headset into standby mode and stop the charging sequence. IMPORTANT: Headset cannot be used while charging. 3 Read the glossary Read the glossary at the end of this document to familiarize yourself with important terms used in this User Manual. Once headset is fully charged, continue with these instructions. 4 "Pair" to your Bluetooth phone Pairing3 will create a unique and encrypted wireless link between two Bluetooth enabled devices such as your Bluetooth phone and Bluetooth headset. 1. Ensure the headset is off (see Turning headset on/off section). 2. Press and hold until you see a solid blue light (approximately 8 seconds), then release* (see Fig. 3). Fig. 3 3. Set your Bluetooth phone to "discover" the headset by following your phone's instruction guide. Typically, the steps involve going to a "setup", "connect", or "Bluetooth" menu on your phone and then selecting the option to "discover" a Bluetooth device. Fig. 4 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58

4
English
WARNING:
Do not attempt to charge headset with anything other than the AC
adaptor provided. Using another AC adaptor may damage or destroy the headset.
IMPORTANT:
The red indicator light will be on while charging and will turn blue when
charging is complete.
Removing the charger from the headset during charging will put
the headset into standby mode and stop the charging sequence.
IMPORTANT:
Headset cannot be used while charging.
Read the glossary
3
Read the glossary at the end of this document to familiarize yourself with important
terms used in this User Manual.
Once headset is fully charged, continue with these instructions.
Pairing
3
will create a unique and encrypted wireless link between two Bluetooth
enabled devices such as your Bluetooth phone and Bluetooth headset.
1.
Ensure the headset is off
(see
Turning
headset on/off
section)
.
2.
Press and hold
until you see a
solid
blue light (approximately 8
seconds), then release*
(see Fig. 3)
.
3.
Set your Bluetooth phone to “discover” the headset by following your phone’s
instruction guide. Typically, the steps involve going to a “setup”, “connect”, or
“Bluetooth” menu
on your phone
and then selecting the option to “discover” a
Bluetooth device.
“Pair” to your Bluetooth phone
4
Fig. 3
Fig. 4