Samsung WF45H6300AG/A2 User Manual Ver.1 (English, French, Spanish) - Page 13
Drain facility, Flooring, Location considerations, Alcove or closet installation, Undercounter
View all Samsung WF45H6300AG/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
01 Installing your washer Drain facility The recommended height of the standpipe is 18 in/46 cm. The drain hose must be routed through the drain hose clip to the standpipe. The standpipe must be large enough to accept the outside diameter of the drain hose. The drain hose is attached at the factory. Flooring For best performance, you must install your washer on a solidly constructed floor. Wood floors may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting and soft tile surfaces are contributing factors to vibration which can cause your washer to move slightly during the spin cycle. Never install your washer on a platform or weakly supported structure. Location considerations Do not install your washer in areas where water may freeze, since your washer will always retain some water in its water valve, pump, and hose areas. Freezing water can damage the belts,the pump, hoses and other components. Alcove or closet installation MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS: Sides - 1 in / 25 mm Top - 17 in / 432 mm Rear - 5.9 in / 150 mm Closet Front - 2 in / 51 mm If the washer and dryer are installed together, the closet front must have at least a 72 in² (465 cm²) unobstructed air opening. Your washer alone does not require a specific air opening. A. Recessed area A 1 in. (2.5 cm) B 17 in. (43.2 cm) 1 in. (2.5 cm) 27 in. (68.6 cm) 27 in. (68.6 cm) 1 in. (2.5 cm) B. Side view - closet or confined area Undercounter installation (washer only) 2 in. (5 cm) 34 in. (86.4 cm) 5.9 in. (15 cm) 8 JOEE 39.6 in. (100.6 cm) 1 in. (2.5 cm) 27 in. (68.6 cm) 1 in. (2.5 cm) English _13