SanDisk SDSDB-016G-P36 Product Manual - Page 39
Partial Data Block Size
UPC - 619659055660
View all SanDisk SDSDB-016G-P36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Revision 2.2 Chapter 3 - SD Card Interface Description SD Card Product Manual Table 3-26 Data Block Length WRITE_BL_LEN 0 to 8 9 Reserved 29 = 512 bytes 11 12-15 211 = 2048 bytes Reserved Block Length ...... • WRITE_BL_PARTIAL-defines whether partial block sizes can be used in block write commands. Table 3-27 Partial Data Block Size WRITE_BL_PARTIAL 0 1 Definition Only the WRITE_BL_LEN block size, and its partial derivatives in resolution of units of 512 blocks, can be used for block oriented data write. Smaller blocks can be used as well. The minimum block size is one byte. • FILE_FORMAT_GROUP-indicates the selected group of file formats. This field is read-only for ROM. • COPY-marks the card as an original (0) or non-original (1). Once set to non-original, this bit cannot be reset to original. The definition of "original" and "non-original" is application dependent and does not change card characteristics. • PERM_WRITE_PROTECT-permanently protects the entire card contents against overwriting or erasing (all write and erase commands for this card are permanently disabled). The default value is 0 (i.e., not permanently write protected). • TMP_WRITE_PROTECT-temporarily protects the whole card content from being overwritten or erased (all write and erase commands for this card are temporarily disabled). This bit can be set and reset. The default value is 0 (i.e., not write protected). • CONTENT_PROT_APP-indicates whether the content protection application is supported. MultiMediaCards that implement the content protection application will have this bit set to "1." • FILE_FORMAT-indicates the card's file format. This field is read-only for ROM. The formats are defined in Table 3-28. Table 3-28 File Format FILE_FORMAT_GRP 0 0 0 0 1 FILE_FORMAT 0 1 2 3 0, 1, 2, 3 Type Hard disk-like file system with partition table. DOS FAT (floppy-like) w/boot sector only (no partition table). Universal file format. Others/unknown. Reserved. • CRC-carries the checksum for the CSD content. The host must recalculate the checksum for any CSD modification. The default corresponds to the initial CSD contents. © 2004 SanDisk Corporation 3-19 12/08/04