Sanyo DP50747 Owner's Manual - Page 15
Getting Started Required Initial Setup - remote control
View all Sanyo DP50747 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
GETTING STARTED (REQUIRED INITIAL SETUP) 1 Install batteries in remote control (2AA, not included). PRECAUTIONS To ensure safe operation, please observe the following precautions: Replace both batteries at the same time. Do not use a new battery with a used battery. Risk of explosion, if battery is replaced by an incorrect type. Do not expose the Remote Control Unit to moisture or heat. Match the "+" and "-" signs on the batteries with marks inside the remote control. 2 Connect Signal to the DTV's Integrated Analog / Digital 75 ohm Antenna Input terminal. RF ANTENNA OR CABLE OR CABLE BOX OR SATELLITE BOX ANALOG / DIGITAL ANTENNA IN THE TUNER IN THIS DTV CAN RECEIVE: 1. Digital and / or Analog Off-Air Signals from an RF antenna. OR 2. Analog or ClearQAM cable channels. Note:You must search for ClearQAM channels using the "Digital Cable Search" menu option. OR 3. The output from an external device such as; a VCR or cable box. Signals from a Set-top (STB) Box should be received through the Video 1, 2, or 3, or HDMI Input 1, 2, or 3 jacks. This DTV can receive ANY unscrambled RF signal being broadcast. (CONTINUED ON NEXT PAGE.) 15