Sanyo PDG-DET100L Instruction Manual, PDG-DET100L POA-MD13NET2 - Page 15
Connection of LAN cable, Wind the UTP straight cable once
UPC - 086483074684
View all Sanyo PDG-DET100L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Connection of LAN cable Connection of LAN cable To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) strait cable with RJ-45 plug. There are two different types of cables depending on whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or 100Base-TX) to distribute the network cable if required. 1 Turn the Mains switch off. 2 Wind the UTP straight cable once around the ferrite core (supplied) as the illustrated below. Ferrite Core Mains Switch 3 Connect the UTP straight cable to the LAN port on the network board. 4 Connect the UTP straight cable to the hub. ENGLISH Hub (10Base-T, 100Base-TX) UTP straight cable Projector ✐ Use the UTP cross cable when you connect the computer and projector directly not using the hub. ✐ When you connect the projector into the 10Base-T network, use cable with category 3 or 5. When you connect the projector into the 100Base-TX network, use cable with category 5. ✐ The length of cable between hub and projector should be less than 100m. 15 Network Board OWNER'S MANUAL