Sanyo PDG-DSU30 RS232 Expand - Page 18
PC Control Command, CF_FSYNC Command, CF_TDOTS Command, CF_H-POS Command, CF_V-POS Command
UPC - 086483076596
View all Sanyo PDG-DSU30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
PDG-DSU30 Expand Serial Command Functional Specifications 8.5 PC Control Command 8.5.1 CF_FSYNC Command Command "CF_FSYNC_%1" [CR] "0000~0031 Directly specify setting value of Fine sync %1 "UP Increment setting value of Fine sync by 1 "DN Decrement setting value of Fine sync by 1 Details Set value of Fine sync in PC signal (Available only in the normal Power ON status) No display is shown when projector received command. Acceptable Correspondence Unacceptable "000" [CR] "Error Code" [CR] 8.5.2 CF_TDOTS Command Command "CF_TDOTS_%1" [CR] "-005 ~ 0005 Directly specify setting value of Total dots "nnnn" indicates minimum value, which is current %1 (Display Dots + Position H) value "UP Increment setting value of Total dots by 1 "DN Decrement setting value of Total dots by 1 Details Set value of Total Dots in PC signal (Available only in the normal Power ON status) No display is shown when projector received command. Acceptable Correspondence Unacceptable "000" [CR] "Error Code" [CR] 8.5.3 CF_H-POS Command Command "CF_H-POS_%1" [CR] "-005~0005" -------- Directly specify setting value of Horizontal Position %1 "nnnn" indicates maximum value, which is current value of (Total Dots - Display Dots) "UP Increment setting value of Horizontal Position by 1 "DN Decrement setting value of Horizontal Position by 1 Details Set value of Horizontal Position in PC signal (Available only in the normal Power ON status) No display is shown when projector received command. Acceptable Correspondence Unacceptable "000" [CR] "Error Code" [CR] 8.5.4 CF_V-POS Command Command "CF_V-POS_%1" [CR] "-005~0005 Directly specify setting value of Vertical Position %1 "nnnn" indicates maximum value, which is current (Total Line - Display Line) value "UP Increment setting value of Vertical Position by 1 "DN Decrement setting value of Vertical Position by 1 Details Set Vertical Position value in PC signal (Available only in the normal Power ON status) No display is shown when projector received command. Acceptable Correspondence Unacceptable "000" [CR] "Error Code" [CR] 18 / 42