Sanyo PLC-WL2503 RS232C Expand - Page 42

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications 8.10.24 CF_RCODE Command Command "CF_RCODE_%1"[CR] "001 Select Code1 "002 Select Code2 %1 "UP Switch Code setting of Remote Control forward "DN Switch Code setting of Remote Control backward Note) "UP" and "DN" behave the same. Details Select Code of Remote Control The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.25 CF_KEYDIS Command Command "CF_KEYDIS_%1"[CR] "NONE RC & Projector keys are valid (All are valid) %1 "RC RC keys are invalid "KEY Projector keys are invalid Details (This command is available to models with top panel buttons only.) Disable RC/Projector keys This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.26 CF_PJPINCODE Command Command "CF_PJPINCODE_%1"[CR] %1 "0000" - "9999" ---------Set PJ PIN CODE directly Set PJ PIN CODE to release PJ LOCK. PIN CODE cannot be changed by this command. Details -When PJ LOCK is in operation PIN CODE is correct Command is valid (Acceptable) PIN CODE is incorrect Command is invalid(Error Code"102") PIN CODE is out of %1 range Command is invalid (Error Code "? ") -When PJ LOCK is not in operation PIN CODE is within %1 range Command is valid (Acceptable) PIN CODE is out of %1 range Command is invalid (Error Code "? ") Response This command is valid during a dialog "PJ PIN CODE" is displayed after Power On and Count down. Also when PJ LOCK setting is "On1", it is necessary to transmit this command every time lamp turns on. Acceptable "000"[CR] Unacceptable "Error Code"[CR] 41/72