Sanyo PLV-Z60 Owners Manual - Page 30

Image Adjustment Advanced menu This function can be selected only when Advanced menu in the Setting Menu (see page 36) is set to "On." You can adjust the following items through this function. Lamp iris Adjust the lamp aperture. Select from the following options: Auto 1 . . Normal open-close speed Auto 2 . . High open-close speed Open . . . Fully open aperture Close . . . Closed aperture Auto black stretch Enhance blacks in bright areas of an image. It can be set in 4 steps (Off/L1/L2/L3). Contrast enhancement Adjust the contrast in bright scenes in 4 steps (Off/L1/L2/L3). Transient improvement Adjust the sharpness of image outlines in 4 steps (Off/L1/L2/L3). Color management Adjust the level, phase, and gamma of any color. You can store up to eight (8) color management data. For details, see "COLOR MANAGEMENT" on the next page. Color list Select a color list from the following options: List 0 . . . No color correction List 1 . . . Overall correction of memory colors List 2 . . . Skin color correction List 3 . . . Enhancement of the brightness of primary colors User . . . . User correction from the above color lists ✔Notes: • "User" option will not be displayed unless the Color management function is executed. • If no user image mode is stored, the factory default value is displayed. Dynamic gamma Set the level for Dynamic gamma correction. Select from the following options: Off . . . . . Disable dynamic gamma correction Auto 1 . . Small correction Auto 2 . . Large correction ✔Note: • One of the above options are displayed depending on the selected image mode. Gain R/G/B Adjust R, G, B to get the desired contrast (from -15 to +15.) Offset R/G/B Adjust r R, G, B to get the desired brightness (from -15 to +15.) Gamma R/G/B Adjust R, G, B to get the desired balance of contrast (from -5 to +5.) 30 Press the Point d button to move on to the next items. Press the Point 8 or OK buttons to access the selected item. The adjustment bar is displayed. Use the Point 7 8 buttons to adjust the setting values and press the OK button. If you press the Point d button, the next item can be selected.