Schwinn 213 Recumbent Bike Assembly Manual - Page 14

Assembly Stage #7, Attach Handlebar Assembly and Run Cabling Through Handlebar Post

Get Schwinn 213 Recumbent Bike PDF manuals and user guides View all Schwinn 213 Recumbent Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Assembly Stage #7 Attach Handlebar Assembly and Run Cabling Through Handlebar Post Assembly Hardware Required: NONE Step 12: Slide the HANDLEBAR ASSEMBLY (#2) into the receiver on the HANDLEBAR POST (#4). Slide the threaded post into the slider tube and attach the HANDLEBAR ASSEMBLY SLIDER TUBE (#2) and the HANDLEBAR POST (#4) by threading the ADJUSTMENT KNOB (#21) and the SMALL FLAT WASHER (#22) into the threaded post. Place the end cap on the end of the slider tube on the HANDLEBAR ASSEMBLY (#2). Step 13: Take the UPPER HR WIRE (#7) and the UPPER COMPUTER WIRE (#8) and slide them through the HANDLEBAR POST (#4) as pictured above.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
Assembly Stage #7
Attach Handlebar Assembly and Run Cabling Through Handlebar Post
Assembly Hardware Required:
NONE
Step 12:
Slide the HANDLEBAR ASSEMBLY (#2) into the receiver on the
HANDLEBAR POST (#4).
Slide the threaded post into the slider tube and attach the
HANDLEBAR ASSEMBLY SLIDER TUBE (#2) and the HANDLEBAR POST (#4) by
threading the ADJUSTMENT KNOB (#21) and the SMALL FLAT WASHER (#22) into
the threaded post.
Place the end cap on the end of the slider tube on the HANDLEBAR
ASSEMBLY (#2).
Step 13: Take the UPPER HR WIRE (#7) and the UPPER COMPUTER WIRE (#8) and
slide them through the HANDLEBAR POST (#4) as pictured above.