Schwinn A15 Upright Bike Assembly and Owner's Manual

Schwinn A15 Upright Bike Manual

Get Schwinn A15 Upright Bike PDF manuals and user guides View all Schwinn A15 Upright Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Schwinn A15 Upright Bike manual content summary:

  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 1
    Manual en Español Latino Americano: http://www.schwinnfitness.com ASSEMBLY MANUAL / OWNER'S MANUAL
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 2
    4 Before Assembly 5 Parts 6 Hardware 7 Tools 7 Assembly 8 Leveling the Bike 13 Moving the Bike 13 Important Safety Instructions - Owner's 14 Features 15 Console Features 16 Contact Heart Rate (CHR) 17 Operations 19 Adjustments 19 Quick Start / Manual Program 19 Profile
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 3
    connect power supply to the machine until instructed to do so. • Do not parts can cause a risk to users, keep the machine from operating correctly and void the warranty. • Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Manual
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 4
    the user's authority to operate the equipment. The power supply complies with part 15 of the FCC rules. Operation is subject to the following two conditions and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 5
    For safe operation, the location must be on a hard, level surface. Allow a workout area of a minimum 67" x 56" (1.7m x 1.42m). Basic Assembly Tips ) to tighten, and the left (counter- clockwise) to loosen, unless instructed otherwise. 4. When attaching 2 pieces, lightly lift and look through the
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 6
    PARTS 8 7 2 10 (L) 9 6 12 1 5 4 11 (R) 3 Item Qty Description 1 1 Main Frame 2 1 Front Stabilizer 3 1 Rear Stabilizer 4 1 Seat Post 5 1 Adjustment Knob (pre-installed) 6 1 Seat Note: M edia Cable is in the
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 7
    HARDWARE / TOOLs A B Item Qty Description A 4 Carriage Bolt M8 x 65 B 8 Arc Washer M8 C D Item Qty Description C 4 Acorn Nut M8 D 4 Hex Screw M8 x 15 Tools Included Not Included 6 mm (recommended) 13mm/17mm 15 mm 7
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 8
    to Main Frame Note: M ake sure the Schwinn® decal on the Rear Stabilizer faces outward from the machine. X4 A 2 1 X4 3 C B 2. Install Pedals Note: T he Left Pedal is reverse-threaded. Be sure to attach Pedals on the proper side of the Bike. Orientation is based from a seated position on
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 9
    3. Attach Seat to Seat Post and Frame Note: H ardware is pre-installed on Seat and not on Hardware Card. NOTICE: T he Adjustment Knob is pre-installed on the Main Frame. Make sure the Adjustment Knob engages the Seat Post. ! Do not set the Seat Post position higher than the stop mark (MAX) on the
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 10
    5. Install Handlebars on Console Mast Note: Hardware is pre-installed on Console Mast and not on Hardware Card. NOTICE: M ake sure the Handlebar Bracket has an equal distance between the two ends of the bracket and the bracket mount on the Console Mast. Do not crimp the cables. Route the HR cable
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 11
    Console before you connect the cables. NOTICE: D o not crimp the cables. Make sure that the switch on the back of the Console is set to B (bike). 8 #2 7. Install Water Bottle Holder Note: T he hardware is pre-installed on the Console Mast and not on the hardware card. 12 X2 6mm 11
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 12
    If you use a power adapter for your bike, make sure that the cord stays clear of the optional Power Adapter, go to: www.schwinnfitness.com/powersupply Or call 1 (800) manual. ! Do not use or put the machine into service until the machine has been fully assembled and inspected for correct performance
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 13
    Turn the end cap to adjust the level. Make sure the bike is level and stable before you exercise. Moving Your Bike To move the upright bike, carefully tilt the Handlebars toward you while pushing the front of the bike downward. Push the bike to the desired location. NOTICE: Be careful when you move
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 14
    Manual. Keep the Manual for future reference. Read and understand all warnings on this machine. If at any time the Warning stickers become loose, unreadable or dislodged, contact Nautilus® Customer Service for replacement stickers. • Children must not be let on or near to this machine. Moving parts
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 15
    A K J I H G B S C D E F Q P N FEATURES Q O M L R A Console B Handlebars, Upright C Adjustable Seat D Adjustment Knob E Fully Shrouded Flywheel F Levelers G Stabilizers H Transport Rollers I Pedals J Water Bottle Holder K Contact Heart Rate (CHR) Sensors L Power Connector M Battery Bay N Machine
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 16
    of the program selection and the grid area shows the course profile for the program. Each column in the profile shows one interval (workout segment). The higher the column, the higher the resistance level for that interval. The flashing column shows your current interval. Program display Battery
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 17
    the workout. Note: To change the measurement units to English Imperial or metric, refer to the "Changing Unit Measures" section in this manual. RPM rate signals to the Console. The CHR sensors are the stainless steel parts of the Handlebars. To use, put your hands comfortably around the sensors
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 18
    The most efficient procedure to burn fat during exercise is to start at a slow pace and gradually increase your intensity until your heart rate reaches between 60 - 85% of your maximum heart rate. Continue at that pace, keeping your heart rate in that target zone for over 20 minutes. The longer you
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 19
    upright bike. If your leg is bent too much, move the seat up. ! Step off the bike optional power adapter is available from www.schwinnfitness.com/powersupply or call 1(800) 605- Quick Start / Manual Program The Quick Start / Manual program lets you start a workout without entering any information
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 20
    , the Rolling Hills program for the Fun Rides type. Push the button again to toggle between option 1 and option 2. 3. To adjust the time of the workout, push ENTER. The default value is 15 minutes. Use the Increase() or Decrease() buttons to change it, and push ENTER. 4. Use the Increase() and
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 21
    MAINTENANCE Read all maintenance instructions fully before you start any repair work. In some for loose, broken, damaged, or worn parts. Do not use if found in this condition. Repair or replace all parts at the first sign of wear or damage. After each workout, use a damp cloth to wipe your
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 22
    MAINTENANCE H J A E G F I B H XU W T S V R K B L N C M P D O Q D P C O A Console I B Console Mast J C Pedals K D Crank Arms L E Battery Bay M F AC Power Connector N G Machine Type Switch O H Data Cable P Handlebars HR Cables CHR Sensors Seat Seat Post Adjustment
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 23
    ), or rechargeable (Ni-Cd, Ni-MH, etc) batteries. X4 + - Machine Type Switch The Machine Type switch on the Console is preset at the factory to B (bike) or E (elliptical). If you replace the console, it will possibly be necessary to set the switch for your machine. After you set the switch, it
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 24
    Troubleshooting Condition/Problem Things to Check Solution No display/partial display/ If bike has AC adapter, check Make sure unit is plugged into a functioning wall outlet. unit will not turn on electrical (wall) outlet If bike has AC adapter, check Connection should be secure and undamaged
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 25
    removal) Check RPM Sensor Contact Customer Care for further assistance. Check leveler adjustment Leveling feet may be turned in or out to level bike. Check surface under unit Check pedal to crank connection Check crank to axle connection Check pedal to crank connection Check locking pin Check
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 26
    [page intentionally left blank] 26
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 27
    , (Assembly, Owner's Manuals, etc.). • Product must be used exclusively for the purpose intended. • Notify Nautilus within 30 days after detecting an issue with the Product. • Install replacement parts or components in accordance with any Nautilus instructions. • Perform diagnostic procedures with
  • Schwinn A15 Upright Bike | Assembly and Owner's Manual - Page 28
    Nautilus® 8000171.072312.B Bowflex® Schwinn® Fitness Universal®
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
ASSEMBLY MANUAL / OWNER’S MANUAL
Manual en Español Latino Americano:
http://www.schwinnfitness.com