Seagate ST336754SS Cheetah 15K.4 SAS Product Manual - Page 37
The +12V and +5V current profiles for ST3146854SS, ST373454SS and ST336754SS models are shown
UPC - 000064845289
View all Seagate ST336754SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
[4] This condition occurs after OOB and Speed Negotiation completes but before the drive has received the Notify Spinup primitive. [5] See paragraph 6.2.1, "Conducted noise immunity." Specified voltage tolerance includes ripple, noise, and transient response. [6] Operating condition is defined as random 8 block reads with 225 I/Os per second for ST3146854SS drives, 230 I/Os per second for ST373454SS drives, and 230 I/Os per second for ST336754SS drives. Current and power specified at nominal voltages. Decreasing +5 volt supply by 5% increases 5 volt current by 2.5%. Decreasing +12 volt supply by 5% increases 12 volt current by 3.0% for ST3146854SS models, 2.0% for ST373454SS models, and 2.0% for ST336754SS models. [7] During idle, the drive heads are relocated every 60 seconds to a random location within the band from three-quarters to maximum track. General DC power requirement notes. 1. Minimum current loading for each supply voltage is not less than 1.7% of the maximum operating current shown. 2. The +5V and +12V supplies should employ separate ground returns. 3. Where power is provided to multiple drives from a common supply, careful consideration for individual drive power requirements should be noted. Where multiple units are powered on simultaneously, the peak starting current must be available to each device. 4. Parameters, other than spindle start, are measured after a 10-minute warm up. 5. No terminator power. 6.2.1 Conducted noise immunity Noise is specified as a periodic and random distribution of frequencies covering a band from DC to 10 MHz. Maximum allowed noise values given below are peak-to-peak measurements and apply at the drive power connector. 0 to 100 kHz 100 kHz to 10 MHz +5V 150mV 100mV +12V 150mV 100mV 6.2.2 Power sequencing The drive does not require power sequencing. The drive protects against inadvertent writing during power-up and down. 6.2.3 Current profiles The +12V and +5V current profiles for ST3146854SS, ST373454SS and ST336754SS models are shown below in the following figures. Note: All times and currents are typical. See Tables 2 and 3 for maximum current requirements. Cheetah 15K.4 SAS Product Manual, Rev. B 27