Seagate ST373405LW Product Manual - Page 62
REQ/ACK offset
View all Seagate ST373405LW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
52 Cheetah 73LP Product Manual, Rev. C 9.5 Synchronous data transfer 9.5.1 Synchronous data transfer periods supported Table 10 and Section 9.5.2 list Synchronous Data transfer periods supported by the drive. The data transfer period to be used by the drive and the initiator is established by an exchange of messages during the Message Phase of operation. See the section on message protocol in the SCSI Interface Product Manual, part number 75789509. Table 10: Synchronous data transfer periods M (decimal) Transfer period Transfer rate (nanoseconds) (megatransfers/second) 9 12.5 10 25 12 50 25 100 50 200 80.0 [1] [2] 40.0 [1] 20.0 10.0 5.0 [1] This transfer rate is only allowed when using the LVD interface. [2] You must use the Parallel Protocol Request message with this transfer rate. 9.5.2 REQ/ACK offset The maximum value supported by the Cheetah 73LP family drives for REQ/ACK offset is 63 (3Fh). 9.6 Physical interface This section describes the connectors, cables, signals, terminators and bus timing of the DC and SCSI I/O interface. See Section 9.8 and Section 9.9 for additional terminator information. Figures 19 and 20 show the locations of the DC power connector, SCSI interface connector, drive select headers, and option select headers. Details of the physical, electrical and logical characteristics are given in sections following, while the SCSI operational aspects of Seagate drive interfaces are given in the SCSI Interface Product Manual, part number 75789509. 9.6.1 DC cable and connector ST373405LW drives receive DC power through a 4 pin connector (see Figure 21 for pin assignment) mounted at the rear of the main PCBA. Recommended part numbers of the mating connector are listed below, but equivalent parts may be used. Type of cable 14 AWG Connector MP 1-480424-0 Contacts (20-14 AWG) AMP 60619-4 (Loose Piece) AMP 61117-4 (Strip) LC model drives receive power through the 80-pin I/O connector. See Tables 14 and 15.