Sharp AL 1000 AL1000 Operation Manual - Page 36

STATUS INDICATORS When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page. Indication Drum replacement required indicator Cause and remedy Steadily Replacement of drum cartridge will be needed lit soon. Prepare a new cartridge. Blinking Drum cartridge must be replaced. Replace it with a new one. See page: 38 27 TD cartridge replacement Steadily Replacement of TD cartridge will be needed 38 lit soon. Prepare a new cartridge. required indicator Blinking TD cartridge must be replaced. Replace it with a new one. 26 A misfeed has occurred. Remove the misfed 31 Misfeed indicator Blinking paper referring to the description of "Misfeed removal." "CH" is blinking in the display. The TD cartridge is not installed. Check if the 26 cartridge is installed. "CH" is steadily lit in the display. Side cover is open. Close the side cover securely by pressing the round projections near the side cover open button. - Paper tray is empty. Load copy paper. 13 "P" is blinking in the display. A misfeed has occurred in the paper tray. Remove the misfed paper. 31 6 Paper tray is not securely installed. Push the - tray in securely. Copier trouble? The copier will not function. Turn the power - A letter and a number appear switch off, remove the power cord from the alternately. outlet, and contact your authorized service representative. DISPLAYING TOTAL NUMBER OF COPIES Use the following procedure to display the total number of copies. 1 Press the clear ( ) key to reset the display to zero. 2 Press and hold down the clear ( ) key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits. Example: Total number of copies is 1,234. 35