Sharp AR M207 AR-M162 AR-M207 Operation Manual Suite - Page 148
Reading, No.001, P-xxx, Read End, Start]:continue
View all Sharp AR M207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
BASIC OPERATIONS Using the SPF 6 Press the [START] key ( ). Using the document glass 6 Press the [START] key ( ). WXYZ @.-_ READ-END READING No.001 MEMORY CONT AUTO STANDARD XX% P-XXX AUTO A4R WXYZ @.-_ READ-END READING No.001 MEMORY CONT AUTO STANDARD XX% P-XXX AUTO A4R • Scanning begins. • If the line is free, the machine will dial the receiving machine and begin transmission as soon as the first page is scanned. (Quick online transmission: page 25) • If there is a previously stored job or a job is in progress, or if the line is being used, all pages of the original are scanned into memory and stored as a transmission job. (This is called memory transmission: the destination is automatically called and the document transmitted after previously stored jobs are completed.) If scanning is completed normally, the following screen is appears briefly and then the display returns to the base screen. READ END No.001 MEMORY CONT AUTO STANDARD XX% P-XXX AUTO A4R Scanning begins. 7 If you have another page to scan, change pages and then press the [START] key ( ). 2 [START]:CONTINUE [#]:READ-END MEMORY AUTO CONT AUTO A4R STANDARD • Repeat this sequence until all pages have been scanned. • You can change the resolution and exposure settings as needed for each page 15. • If no action is taken for one minute (the [START] key ( ) is not pressed), scanning automatically ends and the transmission job is stored. (This function can be disabled in the key operator programs.) 8 After the last page is scanned, press the [READ-END] key ( ). @.-_ . #-C READ-END READ END No.001 MEMORY CONT AUTO STANDARD XX% P-XXX AUTO A4R Note Open the SPF and remove the original. When the original is removed or any key operation is performed, the display returns to the base screen. (The destination is automatically called and the document transmitted after any previously stored jobs are completed.) • To cancel transmission To cancel transmission while "READING" appears or before the key is pressed, press the [C] or [CA] key. To cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as explained on page 26. • A job number (3 digits) appears in the display with "READ END" when memory transmission is performed. If you make a note of this number after performing a broadcast transmission, you can use the number to check the results of the transmission in the transaction report or activity report. • If the power is turned off or a power failure occurs while an original is being scanned in the SPF, the machine will stop and an original misfeed will occur. After power is restored, remove the original as explained in "ORIGINAL MISFEED IN THE SPF" in the "Operation manual (for general information and copier)". 19