Sharp CD180 QTCD180 Operation Manual - Page 8

Recording to a Cassette Tape Before recording: G When recording important selections, make a preliminary test to en- sure that the desired material is properly recorded. G SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. G The ALC (Automatic Record Level Control) circuit automatically con- trols the level of the input signal used for recording. G The VOLUME control may be adjusted with no effect on the recorded signal. (Variable Sound Monitor) G Metal and CrO2 tapes cannot be used for recording. I Recording from a CD 1 Set the FUNCTION switch to CD. 2 Load the disc to be recorded. 3 Load a blank cassette into the cassette compartment with the side to be recorded facing toward you. 4 Press the RECORD G button. 5 Press the PLAY/PAUSE 0 6 button on the CD. To stop recording: Press the STOP/EJECT I 7 button. If the STOP I or PLAY/PAUSE 0 6 button is pressed while recording, or if the CD comes to its end, the tape deck will not stop. To record a specific track: Press the REVIEW/DOWN 5 or CUE/UP 4 button until the desired track number is displayed, then start recording. I Recording from the radio 1 Set the FUNCTION switch to FM or AM. 2 Tune in to the station to be recorded. 3 Load a blank cassette into the cassette compartment with the side to be recorded facing toward you. 4 Press the PAUSE 6 button. 5 Press the RECORD G button. 6 Press the PAUSE 6 button again. To stop recording: Press the STOP/EJECT I 7 button. I Erasing a recorded tape 1 Set the FUNCTION switch to TAPE. 2 Load a tape into the cassette compartment with the side to be erased facing toward you. 3 Press the RECORD G button. 8