Sharp KB-0333KK KB-0333K Operation Manual / Installation Instructions - Page 5

1 Determine whether hood will discharge vertically (3 1⁄4" x 10" or 7" round), horizontally (3 1⁄4" x 10" only) or be non-ducted. For vertical or horizontal discharge, run ductwork between the hood location and a roof cap or wall cap. For best results, use a minimum number of transitions and elbows. ROOF CAP 31/4" X 10" or 7" ROUND DUCT (For vertical discharge) SOFFIT CABINET HOOD 24" - 30" ABOVE COOKING SURFACE HOUSE WIRING (Top or back of hood) WALL CAP 31/4" X 10" DUCT (For horizontal discharge) 2 Use diagrams for proper placement of ductwork and electrical cutout in cabinet or wall. For a non-ducted installation, DO NOT cut a duct access hole. 31/4" X 10" HOOD MOUNTING SCREWS (4) VERTICAL DUCTING 1315/16" (30" hood) CABINET FRONT 1315/16" (30" hood) 71/2" CABINET BOTTOM 51/4" 51/4" 5" 11/4" VERTICAL DUCT ACCESS HOLE 2" 101/2" 11/2" WOOD SHIMS (Recessed-bottom cabinets only) CENTER LINE ELECTRICAL ACCESS HOLE (In cabinet bottom) PREPARE HOOD LOCATION WOOD SHIMS 31/4" X 10" (Recessed-bottom HORIZONTAL DUCTING cabinets only) CABINET FRONT 1/8" 3/4" 33/4" CABINET HORIZONTAL DUCT ACCESS HOLE BOTTOM 51/4" 51/4" 71/2" 1315/16" (30" hood) 1315/16" (30" hood) HOOD MOUNTING SCREWS (4) CENTER LINE ELECTRICAL ACCESS HOLE (In wall) 7" ROUND VERTICAL DUCTING (Recessed-bottom (In cabinet bottom) NON-DUCTED (Recessed-bottom (In cabinet bottom) 3 Run house wiring between service panel and hood location. 5