Sharp KB3401LK KB-3401LS , KB-3401LK , KB-3401LW Installation Instructions - Page 7
cutout. See
UPC - 074000616172
View all Sharp KB3401LK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3 Level and Position Range • Measure from the countertop to the floor height to determine the height that the back of the range needs to be set at. • Loosen legs and lock nuts to set level of the range. (Note that the lock nuts are only on the rear feet). See Figure 15. Installation Manual NOTE: A minimum clearance of 1/8-inch is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a level to check your adjustments. Plug range into properly prepared electrical receptacle or if hard wired, check that it was completed properly. Check floor condition for evenness and stability. Slide range back into position. See Figure 18. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip bracket by looking underneath the range with a flashlight and carefully attempt to tilt it forward. Figure 15 Range Leg Lock Nut (Rear leg only) • Adjust the back leveling legs with an adjustable wrench or pliers. Measure from the floor to the top of the cooktop glass (X) and adjust the legs to match the measurement (Y) taken from the cutout. See Figure 16. 1 5/8" to edge of bracket Range Slide (Y") floor to top of countertop (X") floor to top of cooktop glass Figure 18 Figure 16 • After leveling, tighten the lock nuts on the rear to prevent the feet from turning when sliding into position. See Figure 17. Figure 17