Sharp LC37D64U LC-32D64U LC-37D64U Operation Manual - Page 23

On-Screen Display Menu Power Control Menu Power control setting allows you to save energy. Example Power Control No Signal Off No Operation Off [Disable] [Disable] 1 Press MENU to display the MENU screen, and then press c/d to select "Power Control". 2 Press a/b to select a "No Signal Off" or "No Operation Off", and then press ENTER. 3 Press c/d to select "Enable", and then press ENTER. 4 Press MENU to exit. No Signal Off When set to"Enable", the power will automatically shut down if there is no signal for 15 minutes. • Five minutes before the power shuts down, the remaining time displays every minute. • "Disable" is the factory preset value. • When a TV program finishes, this function may not operate. No Operation Off When set to "Enable", the power will automatically shut down if there is no operation for 3 hours. • Five minutes before the power shuts down, the remaining time displays every minute. • "Disable" is the factory preset value. Setup Menu Example Setup EZ Setup CH Setup Antenna Setup-DIGITAL Input Skip Parental CTRL Position Language Reset [English] 1 Press MENU to display the MENU screen, and then press c/d to select "Setup". 2 Press a/b to select a specific adjustment item, and then press ENTER. • When you select "EZ Setup", "CH Setup", "Parental CTRL" or "Reset", you can enter the 4-digit secret number here. See page 23 for setting a secret number. 3 Press a/b (or c/d) to select the desired setting, and then press ENTER. 4 Press MENU to exit. EZ Setup You can run EZ Setup again, even after setting up the preset channels. Language: Select from among 3 languages (English, French and Spanish). TV Location: Select "Home" or "Store" for the location where you plan to install the TV. • If you select "Home", AV MODE is set to "STANDARD". • If you select "Store", AV MODE is set to "DYNAMIC (Fixed)". In case no remote control signal is received within 30 minutes, AV MODE will change to "DYNAMIC (Fixed)" automatically. Air/Cable: Make sure what kind of connection is made with your TV when selecting "Air" or "Cable". CH Search: Channel auto search makes the TV look for all channels viewable in the set area. • See "Initial Setup" on page 12 for setting each item. • If no channel is found, confirm the type of connection made with your TV and try EZ Setup again. • If you select "Analog Search Start" and initiate the channel search, the CH Memory for Cable Digital will be deleted. 21