Sharp PG-F317X PG-F317X Operation Manual - Page 53

Setting up the Projector Network Environment ("Network" menu) Pict. SCR PRJ 1 Password Network Disable Help 2 DHCP Client Off 3 TCP/IP MAC Address X X : X X : X X : X X : X X : X X 4 Projector XX-XXXX Menu operation n Page 39 SEL./ADJ. ENTER END 1 Setting a Password If you do not want others to change the setting for the "Network" menu, set a password. a Setting a Password 1 Select "Password", then press ENTER or Q. • The screen for entering the password appears. Setting the Password Network Old Password New Password Reconfirm 2 Press P or R to set the first digit in "New Password", then press Q. 3 Enter the remaining 3 digits, then press ENTER. • To return to the previous digit, press O. 4 Enter the same password in "Reconfirm", then press ENTER. • The status for "Password" changes to "Enable". Note • Once after the password is set, you must en- ter the password to change the "Network" menu settings. a Changing the Password 1 Select "Password", then press ENTER or Q. • The screen for entering the password appears. 2 Enter the password in "Old Password" using P, R, Q and O, then press ENTER. 3 Enter the password in "New Password" using P, R, Q and O, then press ENTER. 4 Enter the same password again in "Reconfirm" using P, R, Q and O, then press ENTER. Note • If you do not need the password protection for the "Network" menu settings anymore, press ENTER without entering new password in steps 3 and 4. • To cancel the password settings, press RETURN. If you forget the password If you forget the password, perform the following procedure to delete it, then set a new password. On the projector, press . Note • If ENTER is held down for more than 5 sec- onds, the operation buttons on the projector will be locked. (See page 48.) • You cannot use the buttons on the remote control to delete the password. 49 Useful Features