Sharp PN-V602 PN-V602 Operation Manual - Page 25

Menu Items STANDBY MODE When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in standby mode. When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup time from standby mode becomes longer. If set to LOW POWER, certain RS-232C commands cannot be used in standby mode, and control via LAN will be disabled. OFF IF NO OPERATION Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit, RS-232C commands, or LAN for over 4 hours. HOT PLUG CONTROL Sets whether to use hot plug control for the PC/AV HDMI and PC/AV DVI-D input terminals. RS-232C/LAN SELECT Selects the method with which to control the monitor from the computer. ID No. SET Assigns ID numbers to monitors connected in a daisy chain (see page 34), using the remote control unit or RS-232 cables. The numbers 1 to 255 are available for ID numbers. If "0" is set, the system regards this as the state where no ID number is set. AUTO ASSIGN ID No. ID No. to be used will be automatically assigned when multiple monitors are connected with RS-232C. Select ON, then press MENU . Perform operations with the primary monitor. BAUD RATE Selects the communication speed used for RS-232C communication. LAN SETUP Configures the settings to control the monitor from the computer via LAN. (See page 45.) AUTO ASSIGN FIXED IP ADDR. Can be enabled when RS-232C/LAN SELECT is LAN and the DHCP CLIENT is OFF. Set the DHCP CLIENT for secondary monitors connected by RS-232C to OFF and a fixed IP address is automatically allocated. If the IP address is a duplicate with a network device other than a monitor, individually change the IP address. OPTION DC OUT SETTING Normally, leave this setting as OFF. When using an optional part, if instruction appears, change the setting accordingly. HDMI AUTO VIEW When ON is selected, the screen size is adjusted automatically according to the screen size control signal included in the video signal input from the AV HDMI input terminal. BRIGHTNESS SENSOR (When connected to the PN-ZR01 (optional) only) When set to ON or ON: DISPLAY, the brightness will automatically change according to the lighting and surrounding brightness. Performs operation with the primary monitor. If set to ON: DISPLAY, the effect will be displayed with a . If connecting to multiple monitors, the brightness of all the monitors will change. The will be displayed on the primary only. When setting BRIGHT in SCHEDULE on the OPTION menu, set BRIGHTNESS SENSOR to OFF. BRIGHTNESS SENSOR SETTING (When connected to the PN-ZR01 (optional) only) Performs adjustments to the brightness sensor. Performs operation with the primary monitor. Set the surrounding brightness and the current screen luminance to AMBIENT BRIGHTNESS and SCREEN BRIGHTNESS. Individually set WHEN LIGHT: and WHEN DARK:. Even if brighter or darker than the set AMBIENT BRIGHTNESS, the screen brightness will not change. CURRENT AMBIENT BRIGHTNESS is shown for reference. COPY SETTING VALUE When the monitor has been connected to multiple monitors with RS-232C, you can copy the primary setting details to the secondary. Perform operations with the primary monitor. Selects the settings to copy with COPY SETTING VALUE TARGET. "PICTURE" ONLY.... Copies the PICTURE menu settings.* ALL Copies all the settings.* Select the ID No. of the monitor that you would like copy to with COPY TO ID No., then select COPY and press MENU . If you select ALL, settings will be copied to all monitors. When you would like to confirm the ID No. that is set to the monitor, select ID No. and press . The ID No. will be displayed on the screen. * Certain setting details such as ANALOG GAIN, ANALOG OFFSET, and DISPLAY COLOR PATTERN cannot be copied. LOGO SCREEN Sets whether or not to display the logo screen. 25 E