Sharp PN-ZB01 Installation Manual - Page 2
Installation procedure - monitor terminal expansion board
UPC - 074000046986
View all Sharp PN-ZB01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Installation procedure ご注意 Caution •• Do not touch the connectors of this product and LCD MONITOR. The static electricity in your body may cause breakdown. •• Touch a grounded source to discharge the static electricity in your body before starting operation. •• The illustrations in this manual are for explanatory purposes and may not exactly represent the actual product. 1 1. Set the main power switch of the monitor to "off" and disconnect the power from the wall outlet. 5 5. Attach the expansion board. Fully insert the connector. 2 2. Spread a thick and soft cloth (such as a blanket) on a level surface, such as a table, and place the monitor on it with its LCD panel facing downward. 3 ネジを 8 個(PN-E421 7 3. Remove the expansion terminal cover. Remove 8 screws (PN-E421: 7 screws). For the location of the expansion terminal cover, refer to the operation manual of the LCD MONITOR. ֦ுΧόʔ Expansion terminal cover 1/& ίωΫλʔ Connector ίωΫλʔ Connector 6 1 4 2 6. Secure the expansion board. Secure the board with the supplied mounting screw and the 2 screws removed in Step 4. Supplied screws 4 2 4. Remove the dummy plate. Remove 2 screws. Dummy plate 7 3 8 個(PN-E421 7 7. Attach the expansion terminal cover. Secure the cover with the 8 screws (PN-E421: 7 screws) removed in Step 3. 1/& Give the dummy plate to the customer and ask them to store it. Always install the dummy plate after removing the expansion board. ʢ"ʣ ʢ"ʣ 8. 上図(A 8. Affix the terminal label in the area indicated by (A) in the above illustration. -2- Printed in China