Sharp PN-ZB01 Installation Manual - Page 3
PN-ZB01, PN-ZB01 Supplemental Manual
UPC - 074000046986
View all Sharp PN-ZB01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Printed in China TCADZ1110MPZZ(1) PN-ZB01 PN-ZB01 Supplemental Manual Instructions for SHARP dealers and service engineers 対応機種 Applicable models LCD MONITOR Available models differ according to region.) PN-A601 (2011年 9 as of September 2011) Please read "For your safety" in the Installation Manual previously. ご注意 Caution ••This product must be Installed and removed by your local SHARP dealers or service engineers. ••Do not touch the connectors of this product and LCD MONITOR. The static electricity in your body may cause breakdown. ••Touch a grounded source to discharge the static electricity in your body before starting operation. ••The illustrations in this manual are for explanatory purposes and may not exactly represent the actual product. 1 1. Set the main power switch of the monitor to "off" and disconnect the power from the wall outlet. 2 2. Spread a thick and soft cloth (such as a blanket) on a level surface, such as a table, and place the monitor on it with its LCD panel facing downward. 3 8 ֦ுΧόʔ Expansion terminal cover 3. Remove the expansion terminal cover. Remove 8 screws. For the location of the expansion terminal cover, refer to the operation manual of the LCD MONITOR. 4 B 4 4. Remove the expansion terminal cover B. Remove 4 screws. Expansion terminal cover B 5 4 5. Remove the dummy plate. Remove 4 screws. Expansion terminal cover B Expansion terminal cover B Dummy plate 6 B 手順 5 4 1)~(4 6. Attach the expansion terminal cover B on the expansion board. Secure the cover with the 4 screws removed in Step 5. Apply the screw in order from (1) to (4). Expansion terminal cover B 7 7. Attach the expansion board. Fully insert the connector. ίωΫλʔ Connector ίωΫλʔ Connector Insert the tip into the hole. 8 4 4 8. Secure the expansion board. Secure the cover with the 4 screws removed in Step 4. 9 3 8 9. Attach the expansion terminal cover. Secure the cover with the 8 screws removed in Step 3. Give the dummy plate to the customer and ask them to store it. Always install the dummy plate after removing the expansion board. ʢ"ʣ 10. 上図(A 10. Affix the terminal label provided with the LCD MONITOR to the area indicated by (A) in the above illustration.