Sharp R-1611 R-1610 , R-1611 , R-1612 Microwave Operation Manual - Page 30

REPLACING PARTS CHARCOAL FILTER Charcoal Filter, Sharp Part number RK-230 which was enclosed with your oven, is used for nonvented, recirculated installation. The filter should be changed every 6 to 12 months depending on use. See page 4 for ordering information. 1. Disconnect power to the oven at the circuit breaker panel or by unplugging. 2. Remove the louver mounting screw from the top center of the louver and push down carefully on the tab at each end of the louver to disengage it. (See illustration.) 3. Pull the louver away from the unit. 4. Change the charcoal filter. 5. Carefully push the louver back into place (engaging both the bottom and top tabs) and replace the screw removed in step 2. Oven light Charcoal filter Screw 2. Open light cover located behind filter mounting by carefully pulling up on the front edge. 3. Remove old light bulb and replace only with equivalent watt bulb available from a Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE BULB LARGER THAN 30 WATTS. 4. Replace the oven light cover by carefully pushing into place. Replace the charcoal filter, if used. Push the louver back into place and replace the louver mounting screw. WORK LIGHT AND NIGHT LIGHT 1. To replace light bulbs, first disconnect power to the oven at the circuit breaker panel or by unplugging. 2. To release cover, remove the screw on the light cover. (See illustration.) 3. Replace light bulbs with equivalent watt bulb available from your Sharp Authorized Servicer or parts distributor. Bulbs are also available at most hardware stores or lighting centers. DO NOT USE A BULB LARGER THAN 30 WATTS. 4. Close light cover and secure with screw removed in step 2. CAUTION: Light cover may become very hot. Do not touch glass when light is on. Hood louver OVEN LIGHT Remove the louver per instructions 1-3 above and charcoal filter, if used. 1. To replace light bulb, first disconnect power to the oven at the circuit breaker panel or by unplugging. Light cover Screw Light bulbs 28