Sharp XE-A202 Quick Installation Guide - Page 1
Sharp XE-A202 - Electronic Cash Register Manual
UPC - 074000048270
View all Sharp XE-A202 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Model XE-A202 For quick set-up, follow the instructions shown below. Note that malfunction may occur if you do not follow the steps. For further information, please read the instruction manual. Before setting up your cash register, prepare three new R6 or LR6 batteries ("AA" size), which are necessary for memory backup, and find a stable surface near an AC outlet where the cash register is not subject to water sources or direct sunlight. 1 Installing The Cash Register Install the cash register using the fixing angle bracket provided with the register. • Thoroughly clean the location where the fixing angle bracket (B) is to be placed. • Peel off the adhesive tape on the fixing angle bracket. • Hook the angle bracket onto the hook (A) that is located at the bottom rear of the register. • Firmly stick the fixing angle bracket to the table surface that you cleaned above. To remove the register from the fixing angle bracket. • Lift up the front of the register and pull the register towards you. Important Notice The cash register will operate correctly only after the following steps have been carried out: REG OPX/Z MGR X1/Z1 X2/Z2 PGM Mode Lock 2 Preparing The Cash Register REG OPX/Z MGR X1/Z1 Initialising The Cash Register X2/Z2 To ensure the cash register operates correctly, initialize it using the following PGM procedure. • Make sure the AC power cord is unplugged and batteries are not installed Mode Lock in the register. • Insert the manager (MA) key into the mode switch and turn to the REG position. • Insert the plug of the AC power cord into the AC outlet. A buzzer will sound 3 times. IMPORTANT: This operation must be performed without batteries installed. • The register display should now show " 0.00". NOTE: If the buzzer does not sound when the plug is inserted, the initialization has not been done successfully. Wait at least one minute after pulling out the plug, and insert the plug again. Installing the Batteries Install three new R6 or LR6 batteries ("AA" size) according to the procedure shown below with the power cord connected and set the mode switch to REG position. • Lift the rear of the printer cover and detach it. • Open the battery compartment cover. • Install three new R6 or LR6 batteries ("AA"size) as per the diagram. When the batteries are properly installed " " on the display will disappear. • Close the battery compartment cover.