Singer Confidence 7363 Instruction Manual - Page 86
Performance Checklist
View all Singer Confidence 7363 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
5. PERFORMANCE CHECKLIST GENERAL PROBLEMS Machine does not sew. * Power switch is turned off.- Turn on the switch. * Buttonhole lever is not raised when sewing stitch patterns. - Raise buttonhole lever. * Buttonhole lever is not lowered when sewing buttonhole. - Lower buttonhole lever. Machine jams/knocks. * Thread is caught in hook.- Clean hook (see page 80 - 81). * Needle is damaged.- Replace needle (see page 24 - 25). Fabric does not move. * Presser foot is not lowered - Lower presser foot. * Stitch length is too short - Lengthen stitch length. * Feed dogs are lowered - Raise feed dogs. Desired pattern cannot be selected. * Twin needle mode switch has been turned on and lit red. - Turn off the switch. STITCHING PROBLEMS Machine skips stitches. * Needle is not all the way up into needle clamp (see page 24 - 25). * Needle is bent or blunt. - Replace needle (see page 24 - 25). * Machine is not threaded correctly (see page 20 - 21). * Thread is caught in hook. - Clean hook (see page 80 - 81). Stitches are irregular. * Needle size is not correct for thread and fabric (see page 24 - 25). * Machine is not threaded correctly (see page 20 - 21). * Top thread tension is too loose (see page 26 - 27). * Fabric is being pulled or pushed against machine feeding action. - Guide it gently. * Bobbin has not been wound evenly. - Rewind bobbin. Needle breaks. * Fabric is being pulled or pushed against machine feeding action. - Guide it gently. * Needle size is not correct for thread and fabric (see page 24 - 25). * Needle is not all the way up into the needle clamp (see page 24 - 25). THREAD PROBLEMS Thread bunches. * Top and bobbin threads are not drawn back under presser foot before starting seam. - Draw both threads back under presser foot about 4 inches (10 cm) and hold until a few stitches are formed. Needle thread breaks. * Machine is not threaded correctly (see page 20 - 21). * Top thread tension is too tight (see page 26 - 27). * Needle is bent. - Replace needle (see page 24 - 25). * Needle size is not correct for thread and fabric (see page 24 - 25). Bobbin thread breaks. * Bobbin case is not threaded correctly (see page 18 - 19). * Lint accumulates in bobbin case or hook. - Remove lint (see page 80 - 81). Fabric puckers. * Top thread tension is too tight. - Adjust thread tension (see page 26 - 27). * Stitch length is too long for sheer or soft fabric. - Shorten stitch length. 86