Snapper RE100 Operater's Manual - Page 24
Maintenance, Engine Adjustments and Repair, Mower Deck and Component, Adjustments, WARNING - owners manual
View all Snapper RE100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Maintenance ! WARNING ! DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap must be closed securely to prevent fuel spillage. ! WARNING ! DO NOT operate machine until blade brake is adjusted and functioning properly. If blade stop time can not be achieved with the adjustment procedure described above, take machine immediately to an authorized Snapper dealer. Engine Adjustments and Repair Refer to the engine manual for those adjustments and/or A repairs that can be made by the owner. Mower Deck and Component C Adjustments The following mower deck and component adjustments and repairs can be made by the owner. However, if there is difficulty in achieving these adjustments and repairs, it is r n recommended that these repairs be made by an authorized dealer. fo tio Blade Brake Adjustment The automatic Blade Brake should stop the blades within 3 t c seconds any time the blades are disengaged by moving the o blade lever to the "OFF" position or by releasing the Blade u Pedals. If the blades take longer than 3 seconds to stop, N d perform the following measurement and adjustment. 1. With the blade engagement lever disengaged, measure o the distance between the front of the blade lever (A, r Figure 31) and the edge of the latch plate (B). The dimension (C) should be 3" to 3-1/4" clearance between p the lever and the edge of the plate. If the dimension is incorrect go to step 2. e 2. Remove the belt cover. Refer to the section entitled R "BLADE BELT COVER REMOVAL". B Figure 31: Measuring blade brake clearance 3. If the dimension is greater than 3-1/4", rotate the brake adjustment nut (A, Figure 32) clockwise to increase + brake tension. If the dimension is less than 3", rotate the nut counter-clockwise to decrease brake tension. 4. Reinstall the belt cover and tighten the bolts securely. B - ! WARNING ! Once blade is disengaged it should come to a stop in 3 seconds or less. If the blade continues to rotate after 3 seconds the blade brake must be adjusted. DO NOT continue to operate the machine if the blade brake is not operating properly. Figure 32: Adjusting blade brake tension 24 www.snapper.com