Sony CDX-GT22W Operating Instructions - Page 5

Getting Started Resetting the unit (CDX-GT32W only) Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit. Detach the front panel and press the RESET button with a pointed object, such as a ball-point pen. RESET button Note Pressing the RESET button will erase the clock setting and some stored contents. To display the clock, press (DSPL). Press (DSPL) again to return to the previous display. Detaching the front panel You can detach the front panel of this unit to prevent theft. Caution alarm If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used. 1 Press (OFF). The unit is turned off. 2 Press , then pull it off towards you. Preparing the card remote commander (CDX-GT32W only) Before using the card remote commander for the first time, remove the insulation film. Tip For how to replace the battery, see "Replacing the lithium battery of the card remote commander" on page 13. Setting the clock The clock uses a 12-hour digital indication. 1 Press and hold the select button. The setup display appears. 2 Press the select button repeatedly until "CLOCK-ADJ" appears. 3 Press (SEEK) +. The hour indication flashes. 4 Rotate the volume control dial to set the hour and minute. To move the digital indication, press (SEEK) -/+. 5 Press the select button. The setup is complete and the clock starts. Notes • Do not drop or put excessive pressure on the front panel and display window. • Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray. Attaching the front panel Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks. A B Note Do not put anything on the inner surface of the front panel. 5