Sony CDX-SW200 Primary User Manual - Page 18

Radio reception Preset tuning is not possible. • Store the correct frequency in the memory. • The broadcast signal is too weak. The stations cannot be received. The sound is hampered by noises. • Connect a power antenna control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's antenna booster. (Only when your car has built-in FM/AM antenna in the rear/side glass.) • Check the connection of the car antenna. • The auto antenna will not go up. t Check the connection of the power antenna control lead. • Check the frequency. Automatic tuning is not possible. • The local seek mode is set to "ON." t Set the local seek mode to "OFF" (page 11). • The broadcast signal is too weak. t Perform manual tuning. The "ST" indication flashes. • Tune in the frequency accurately. • The broadcast signal is too weak. t Set the monaural reception mode to "ON" (page 11). A program broadcast in stereo is heard in monaural. The unit is in monaural reception mode. t Cancel monaural reception mode (page 11). Error displays/Message Error displays The following indications will flash for about 5 seconds (and in the case of "Err04", an alarm will be heard). Err04 A CD is dirty or inserted upside down. t Clean or insert the CD correctly. Err50 The connection of speakers/amplifiers is incorrect. t See the installation guide manual of this model to check the connection. Err60 There may be an internal malfunction. t Check the connection. If the error indication remains on in the display, consult your nearest Sony dealer. Err99 The CD unit cannot be operated because of some problem. t Press the RESET button on the unit. Message " " or " " You have reached the beginning or the end of the disc and you cannot go any further. If these solutions do not help improve the situation, consult your nearest Sony dealer. 18