Sony CMT-HPZ9 Operating Instructions - Page 32
Tuner, Tape deck, Optional components, If the system still does not, operate properly after performing
View all Sony CMT-HPZ9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Tuner Severe hum or noise/stations cannot be received. • Set the proper band and frequency (page 18). • Connect the antenna properly (page 10). • Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna. • The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully. • Locate the antennas as far away from the speaker cords as possible. • Consult your nearest Sony dealer if the supplied AM antenna has come off the plastic stand. • Try turning off surrounding electrical equipment. • Set "CD POWER" and "OFF" by CD power manage function (page 19). A stereo FM program cannot be received in stereo. • Press FM MODE until "STEREO" appears in the display. Tape deck The tape does not record or play, or there is a decrease in sound level. • The heads are dirty. Clean them (page 35). • The record/playback heads are magnetized. Demagnetize them (page 35). The tape does not erase completely. • The record/playback heads are magnetized. Demagnetize them (page 35). There is excessive wow or flutter, or the sound drops out. • The capstans in the tape deck are dirty. Clean them (page 35). Noise increases or the high frequencies are erased. • The record/playback heads are magnetized. Demagnetize them (page 35). The tape does not record. • No cassette is loaded. Load a cassette. • The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 35). • The tape has wound to the end. Optional components There is no sound. • Refer to General item "There is no sound." (page 30) and check the condition of the system. • Connect the component properly (page 28) while checking: - if the cords are connected properly. - if the cord plugs are firmly inserted all the way. • Turn on the connected component. • Refer to the operating instructions supplied with the connected component and start playing. • Press FUNCTION repeatedly to select "MD" (page 29). The sound is distorted. • Set the volume of the connected component lower. If the system still does not operate properly after performing the above measures, reset the system as follows: Use buttons on the unit for the operation. 1 Disconnect the power cord. 2 Reconnect the power cord. 3 Press ?/1 to turn on the system. 4 Press x, ILLUMINATION and ?/1. The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer. 32GB