Sony DSX-A30 Operating Instructions - Page 20
Troubleshooting
View all Sony DSX-A30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Selectivity: 75 dB at 400 kHz Signal-to-noise ratio: 80 dB (stereo) Separation: 50 dB at 1 kHz Frequency response: 20 - 15,000 Hz AM Tuning range: 530 - 1,710 kHz Antenna (aerial) terminal: External antenna (aerial) connector Intermediate frequency: 9,115 kHz or 9,125 kHz/5 kHz Sensitivity: 26 μV USB Player section Interface: USB (Full-speed) Maximum current: 500 mA Power amplifier section Output: Speaker outputs Speaker impedance: 4 - 8 ohms Maximum power output: 50 W × 4 (at 4 ohms) General Outputs: Audio outputs terminal (rear) Power antenna (aerial)/Power amplifier control terminal (REM OUT) Inputs: Remote controller input terminal Antenna (aerial) input terminal AUX input jack (stereo mini jack) USB port Power requirements: 12 V DC car battery (negative ground (earth)) Dimensions: Approx. 178 × 50 × 120 mm (7 1/8 × 2 × 4 7/8 in) (w/h/d) Mounting dimensions: Approx. 182 × 53 × 103 mm (7 1/4 × 2 1/8 × 4 1/8 in) (w/h/d) Mass: Approx. 0.7 kg (1 lb 9 oz) Supplied accessories: Remote commander: RM-X211 Parts for installation and connections (1 set) Your dealer may not handle some of the above listed accessories. Please ask the dealer for detailed information. 20 Design and specifications are subject to change without notice. Troubleshooting The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. For details on using the fuse and removing the unit from the dashboard, refer to the installation/connections manual supplied with this unit. If the problem is not solved, visit the support site on the back cover. General No power is being supplied to the unit. Check the connection or fuse. If the unit is turned off and the display disappears, it cannot be operated with the remote commander. - Turn on the unit. The power antenna (aerial) does not extend. The power antenna (aerial) does not have a relay box. No sound. The ATT function is activated. The position of the fader control "FADER" is not set for a 2-speaker system. No beep sound. The beep sound is canceled (page 16). An optional power amplifier is connected and you are not using the built-in amplifier.