Sony ILCE-7M3K Help Guide - Page 634
Precautions
View all Sony ILCE-7M3K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 634 highlights
Help Guide Interchangeable Lens Digital Camera ILCE-7M3 α7III Precautions Refer also to "Notes on using your camera" in the Instruction Manual (supplied) for this product. Backing up memory cards Data may be corrupted in the following cases. Be sure to back up the data for protection. When the memory card is removed, the USB cable is disconnected, or the product is turned off in the middle of a read or write operation. When the memory card is used in locations subject to static electricity or electrical noise. Database file error If you insert a memory card that does not contain an image database file into the product and turn on the power, the product automatically creates an image database file using some of the memory card's capacity. The process may take a long time and you cannot operate the product until the process is completed. If a database file error occurs, export all images to your computer using PlayMemories Home, and then format the memory card using this product. Do not use/store the product in the following places In an extremely hot, cold or humid place In places such as in a car parked in the sun, the camera body may become deformed and this may cause a malfunction. Storing under direct sunlight or near a heater The camera body may become discolored or deformed, and this may cause a malfunction. In a location subject to rocking vibration Near strong magnetic place In sandy or dusty places Be careful not to let sand or dust get into the product. This may cause the product to malfunction, and in some cases this malfunction cannot be repaired. In places with high humidity This may cause the lens to mold. On storing If the camera is dirty after use, clean it. Water, sand, dust, salt, etc. left in the camera may cause a malfunction. Precaution on carrying Do not carry the camera with the tripod attached. This may cause the tripod socket hole to break. Do not apply excessive force to the camera, such as by holding the monitor or flash part, hitting the lens part, etc. On operating temperatures Shooting in extremely cold or hot places that exceed this range is not recommended. On moisture condensation If the product is brought directly from a cold to a warm location, moisture may condense inside or outside the product. This moisture condensation may cause a malfunction of the product. To prevent moisture condensation when you bring the product directly from a cold to a warm location, first put it in a plastic bag and seal it to prevent air from entering. Wait for about an hour until the temperature of the product has 634