Sony KV-36HS510 Operating Instructions (primary manual) - Page 44

SETUP SETUP Remote Control Programming the Remote Control The remote control is preset to operate Sony brand video equipment. Sony Equipment Beta, ED Beta VCRs 8 mm VCR VHS VCR DVD player Switch Position on Remote Control AV1 AV2 AV3 DVD Programmable Code Number 303 302 301 751 If you have video equipment other than Sony brand that you want to control with the TV's remote control, use the following procedure to program the remote control. ✍ The equipment must have infrared (IR) remote capability in order to be used with the remote control. z ❑ If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment. ❑ If you enter a new code number, the code number you previously entered at that setting is erased. ❑ In some cases, you may not be able to operate your equipment with the supplied remote control. In such cases, use the equipment's own remote control unit. ❑ Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reset. 1 Turn to the list of "Manufacturer's Codes" on page 44, and find the three-digit code number for the manufacturer of your equipment. (If more than one code number is listed, use the number listed first.) 2 Set the A/V slide switch to 1, 2, 3, or DVD. 3 Press CODE SET. 4 Enter the three-digit manufacturer's code number. 5 Press ENTER. ✍ You must do step 5 within 10 seconds of step 4, or you must redo steps 3 through 5. 6 To check if the code number works, aim the TV's remote control at the equipment and press the POWER button that corresponds with that equipment. If it responds, you are done. If not, try using another code listed for that manufacturer. SETUP SETUP SETUP 43