Sony MZ-G750 Operating Instructions - Page 17

To stop recording, press x. After you press x, the recorder will automatically turn off after: - about 5 minutes when using AC power adaptor. - about 10 seconds when using batteries. Notes • "Data Save" or "TOC Edit" flashes while data of the recording (the track's start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display. • The lid does not open until "TOC Edit" disappears in the display. To Press Record from the end of the END SEARCH, and then press and previous recording1) slide REC. Record partway through the previous recording1) N, > or . to find the start point of recording and press x to stop. Then press and slide REC. Pause X2) Press X again to resume recording. Remove the MD x and open the lid.3) (The lid does not open while "TOC Edit" flashing in the display.) 1) By setting "REC-Posi" to "From End", recording operations will always start from the end of the previously recorded material (page 31). 2) A track mark is added at the point where you press X again to resume recording while pausing; thus the remainder of the track will be counted as a new track. 3) If you open the lid and re-insert the same disc while "REC-Posi" is set to "From Here," recording will continue from the point where it last ended. If you insert another disc, recording will start from the beginning of the disc. Check the point to start recording on the display. If the recording does not start • Make sure the recorder is not locked (page 42). • Make sure the MD is not record-protected (page 62). • Premastered MDs cannot be recorded over. For models supplied with the AC plug adaptor If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor. 17