Sony PEG-TH55 Read This First Operating Instructions - Page 67
My CLIÉ handheld does not work properly, I cannot turn on my CLIÉ handheld
View all Sony PEG-TH55 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Troubleshooting My CLIÉ handheld does not work properly I cannot turn on my CLIÉ handheld B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode (page 88) ? Your CLIÉ handheld does not work when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode. Note If you press the application buttons, Data Assistant button, or CAPTURE button, slide down the VOICE REC switch, or open the camera lens cover during HOLD mode, the POWER LED blinks 3 times. However, your CLIÉ handheld does not operate. B Has the battery power of your CLIÉ handheld run out? Connect your CLIÉ handheld to the AC power adapter with the plug adapter, then allow it to be charged for a few minutes before turning it on. If it turns on, continue charging for approximately five hours and then perform a soft reset (page 47). B Is the connector between your CLIÉ handheld and the plug adapter dirty? You cannot charge your CLIÉ handheld if the connector is dirty. Connect and disconnect your CLIÉ handheld and the plug adapter several times to clean the connector. B Perform a soft reset by pressing the RESET button of your CLIÉ handheld (page 47). The screen is not displayed even though the POWER LED is on B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode (page 88) ? The screen is not displayed when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode. B Perform a soft reset by pressing the RESET button of your CLIÉ handheld (page 47). My CLIÉ handheld does not respond B Is the POWER/HOLD switch of your CLIÉ handheld in HOLD mode (page 88) ? Your CLIÉ handheld does not operate when the POWER/HOLD switch is in HOLD mode. Make sure you release HOLD mode. B Is your CLIÉ handheld placed near the IR port of your computer? Move your CLIÉ handheld away from the IR port of your computer except when performing the IR HotSync® operation, as a malfunction may occur. You can also disable the IR feature by selecting [Off] next to [Beam Receive:] in [General] of the Preferences screen. B Perform a soft reset by pressing the RESET button of your CLIÉ handheld (page 47). Continued on next page 67