Sony SA-32SE1 Operating Instructions - Page 12
Installing the unit on a wall, Installing the unit to the TV Except for China model - all in one speaker
View all Sony SA-32SE1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installing the unit on a wall You can secure the unit on a wall. Notes • Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach the screws securely to a wall beam. Install the speaker on a vertical and flat reinforced area of the wall. • Be sure to subcontract the installation to Sony dealers or licensed contractors and pay special attention to safety during the installation. • Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength, improper screw installation or natural calamity, etc. 1 Prepare screws (not supplied) that are suitable for the hook on the rear of the unit. See the illustrations below. 4 mm (3/16 in) 5 mm (7/32 in) more than 25 mm (1 in) 10 mm (13/32 in) Hook on the rear of the unit 2 Fasten the screws to the wall. The screws should protrude from the wall. See the illustration below. 310 mm (12 1/4 in) (For SA-32SE1) or 320 mm (12 5/8 in) (For SA-40SE1/SA-46SE1) 7 mm to 8 mm (9/32 in to 11/32 in) (For SA-32SE1) or 8 mm to 9 mm (11/32 in to 3/8 in) (For SA-40SE1/ SA-46SE1) 3 Hang the unit onto the screws. Align the holes on the rear of the unit to the screws, then hang the unit onto the two screws. Installing the unit to the TV (Except for China model) You can install this unit to the TV using the optional speaker attachment bracket. For details on the compatible TV model and the speaker attachment bracket, refer to the supplied "Compatible list". 12GB