Sony STR DA5500ES Operating Instructions - Page 136

EQ settings You can use following parameters to adjust the tonal quality (bass/treble level) of front, center and surround/surround back speakers. Bass Treble Level (dB) Frequency (Hz) Notes • This function does not work in the following cases. - The multi-channel input is selected. - "2ch Analog Direct" is being used. - Dolby TrueHD signals with a sampling frequency of 176.4 kHz and higher are being received. • If the equalizer is adjusted while the receiver is receiving signals with a sampling frequency of 176.4 kHz and higher, the signals will always be played back at either 44.1 kHz or 48 kHz. To adjust the equalizer on the EQ screen 1 Press B/b to select the speaker on the screen you want to adjust, then press . 2 Press B/b to select "Bass" or "Treble." 3 Press V/v to adjust the gain, then press . Multi Zone settings You can make settings for the main zone, zone 2 or zone 3. Multi Zone Setup To turn the power on or off for zone 2/zone 3 You can turn zone 2 or zone 3 operation on or off. "Main" (this receiver) is always selected. You cannot turn it off. 1 Press V/v to select the zone you want to turn on or off, then press . 2 Press V/v to select "ON" or "OFF," then press . x ON x OFF To select the output source for each zone You can select the source that is output to the zone. Audio and video signals are output to zone 2, while only audio signals are output to zone 3. 1 Press V/v to select the zone to which you want to output audio/video signals, then press . 2 Press B/b to select "Input," then press . 3 Press V/v to select the input, then press . 136GB