Sony STR-DE495 Operating Instructions - Page 40
Changing the factory, setting of an input selector, button - remote control
View all Sony STR-DE495 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Remote button description (continued) Remote Button ÷ Operations TV TV/VIDEO TV TV VOL TV +/- TV CH TV +/- Function Selects the channel entry mode, either one or two digit Selects input signal: TV input or video input. Adjusts the volume of the TV Selects preset TV channels Notes • When you press the input selector buttons (VIDEO 1, VIDEO 2, DVD), the input mode of the TV might not switch to the corresponding input mode that you want. In this case, press the TV/VIDEO button to switch the input mode of the TV. • Some functions explained in this section may not work depending on the model of the receiver. • The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described. • (STR-DE495 only) The MULTI CH function is not available for set operation. Changing the factory setting of an input selector button If the factory settings of the input selector buttons do not match your system components, you can change them. For example, if you have a tape deck and you do not have an MD deck, you can assign the MD/TAPE button to your tape deck. Note that the settings of the TUNER button cannot be changed. 1 Hold down the input selector button whose input source you want to change (for example, MD/TAPE). 2 Press the corresponding button of the component you want to assign to the input selector button (for example, 4 - Tape deck). The following buttons are assigned to select the input source: To operate CD player Press 1 DAT deck MD deck Tape deck A Tape deck B LD player VCR (command mode VTR 1*) VCR (command mode VTR 2*) VCR (command mode VTR 3*) TV DSS (Digital Satellite Receiver) DVD VCD player 2 3 4 5 6 7 8 9 0 >10 ENTER . * Sony VCRs are operated with a VTR 1, 2 or 3 setting. These correspond to Beta, 8mm and VHS respectively. Now you can use the MD/TAPE button to control the tape deck. To reset a button to its factory setting Repeat the above procedure. To reset all the input selector buttons to their factory setting Press ?/1, AV ?/1 and MASTER VOL - at the same time. 40GB