Sony STR-DN1040 Operating Instructions (Large File - 14.3 MB) - Page 118
Set Audio Out to AMP in the, You can enjoy High Bitrate Audio - hdmi problems
View all Sony STR-DN1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
- Be sure to select the correct equipment or input you want when you watch a program from the equipment connected to the TV. Refer to the operating instructions of the TV on this operation. • When "2ch Analog Direct" is being used, the sound is not output. Use other sound field (page 55). • When using the Control for HDMI function, you cannot control the connected equipment using TV's remote control. - Depending on the connected equipment and TV, you may need to set up the equipment and TV. Refer to the operating instructions supplied with each equipment and TV. - Change the input of the receiver to the HDMI input connected to the equipment. • Check that the selected digital audio input jack is not assigned to other inputs (page 86). The left and right sounds are unbalanced or reversed. • Check that the speakers and equipment are connected correctly and securely. • Adjust the sound level parameters using the Speaker Settings menu. Dolby Digital or DTS multi channel sound is not reproduced. • Check that the DVD, etc. you are playing is recorded in Dolby Digital or DTS format. • When connecting the DVD player, etc., to the digital input jacks of this receiver, make sure the digital audio output setting of the connected equipment is available. • Set "Audio Out" to "AMP" in the HDMI Settings menu (page 99). • You can enjoy High Bitrate Audio (DTS-HD Master Audio, Dolby TrueHD), DSD and Multi Channel Linear PCM with an HDMI connection only. The surround effect cannot be obtained. • Make sure you have selected the sound field for movie or music (page 55). • Sound fields do not function when DTS-HD Master Audio, DTS-HD High Resolution Audio or Dolby TrueHD with sampling frequency of more than 48 kHz are being received. A test tone is not output from the speakers. • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have shortcircuit problem. • Make sure that you are not using PARTY STREAMING function (page 72). A test tone is output from a different speaker than the speaker displayed on the TV screen. • The speaker pattern set up is incorrect. Make sure that the speaker connections and the speaker pattern match correctly. When the receiver is in standby mode, there is no sound output from the TV. • When the receiver enters into standby mode, sound is from the last HDMI equipment selection before you turned off the receiver. If you are enjoying other equipment, play the equipment and perform the One-Touch Play operation, or turn on the receiver to select the HDMI equipment you want to enjoy. • Make sure "Pass Through" is set to "On" in the HDMI Settings menu if you connect equipment not compatible with the "BRAVIA" Sync to the receiver (page 99). 118US