Stihl BR 550 Technical Guide - Page 16
Technical Information, Set valve clearance, slight suction, twice, Assembly, arrows - ignition coil
View all Stihl BR 550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Page 16 5.4.5 Set valve clearance Technical Information 08.2005 5.4.6 Assembly Use the gaskets in kit 4282 007 1001 "Parts for adjusting valve clearance". . Insert setting gauge (1) between rocker arm and valve stem Depending on the momentary valve clearance: . Turn nut (2) clockwise to reduce the valve clearance or anticlockwise to increase it - the setting gauge must produce a slight suction effect when it is pulled through . Rotate the crankshaft twice until the tip of the flywheel is flush with the ignition coil. . Check the valve clearance again and re-adjust if necessary . Fit gasket (1) in position (arrows) . Fit valve cover and tighten screw with a torque of 6 Nm . Mount the air guide shroud . Screw in spark plug, fit shroud, and plug in spark plug boot . Fit starter cover and tighten down screws . Start engine and let it warm up . Switch off engine . Check engine does not leak TI_08_2005_11_01_02.fm