Symphonic WF32L6 Owner's Manual - Page 13
Channel Settings
View all Symphonic WF32L6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
INITIAL SETTINGS / CHANNEL SETTINGS CHANNEL SETTINGS AUTOSCAN If you switch wires (e.g. between antenna and CATV) or if you move the TV to a different area after the initial setting, you need to perform Autoscan again. This function lets you easily select the receivable channels with [CH K/L] and the TV memorizes them even if you switch wires. -0 SETUP STILL SCREEN MODE ENTER BACK INFO CH RETURN VOL. MUTE CH NOTE: • Make sure if the TV is connected to antenna or cable. 1 Display the setup screen. • Press [SETUP]. The following setup screen is displayed. 2 Select "CHANNEL" and press [ENTER] to con- firm. • Using [K/L], select "Autoscan". Channel Autoscan Channel List Manual Register Antenna 3 For TV channels, using [K/L], select "Air". For CATV channels, select "Cable". Autoscan Autoscan will rescan all channels. This may take a while to complete. Select the destination of "ANT IN" jack. Air Back Air Cable Cable 1hour Cable Or ANT IN • Press [ENTER]. Scanning and memorizing the channels automatically starts. Now the system is scanning for channels, please wait. 72% Analog channels Digital channels SETUP Exit 10ch 6ch • When the scanning and memorizing are completed, the lowest memorized channel in the broadcasting will be displayed. NOTES: • If you connect a cable system directly, contact the CATV installer. • If you press [POWER] or [SETUP] during Autoscan, this setting will be canceled. • If there is no reception connected or poor signal is detected, a Hint will appear on screen once scanning stops. • Press [ENTER]. 13 EN