TEAC AP-505 Firmware Update Manual

TEAC AP-505 Manual

Get TEAC AP-505 PDF manuals and user guides View all TEAC AP-505 manuals
Add to My Manuals
Save this manual to your list of manuals

TEAC AP-505 manual content summary:

  • TEAC AP-505 | Firmware Update Manual - Page 1
    manual Model covered AP-505 Equipment used Windows computer (with built-in USB 2.0 port) Micro USB cable oo Cables designed only for charging cannot be used. Always use a micro USB cable that supports data transmission. Supported , and disconnect everything except the power cord from it. 2 Turn the
  • TEAC AP-505 | Firmware Update Manual - Page 2
    manual for the location of the maintenance port. oo Cables designed only for charging cannot be used. Always use a micro USB cable that supports close the window. 7 Disconnect the micro USB cable and power cord. After disconnecting the power cord, leave the unit as is and wait for two minutes
  • 1
  • 2
1
Z
Firmware update manual
Continued on the next page
e
Model covered
AP-505
Equipment used
Windows computer (with built-in USB 2.0 port)
Micro USB cable
o
Cables designed only for charging cannot be used. Always use a
micro USB cable that supports data transmission.
Supported operating systems
Windows 7 (32/64-bit)
Windows 8 (32/64-bit)
Windows 8.1 (32/64-bit)
Windows 10 (32/64-bit)
(as of September 2020)
1. Check the firmware version
1
Put the unit into standby, and disconnect
everything except the power cord from it.
2
Turn the unit on.
3
Switch the INPUT SELECTOR on the back of the
unit three times rapidly.
The level meters show the firmware version.
Version
LEFT
RIGHT
1.00
−40 dB
−∞
1.01
0 dB
−∞
1.02
0 dB
−40 dB
1.03
0 dB
0 dB
2. Install the DFU driver
Set the unit’s STANDBY/ON switch to STANDBY, and begin the fol-
lowing operations before connecting it with the computer.
NOTE
o
After installing the DFU driver on the computer once, installing it
again will not be necessary. If installation is complete, proceed to
“3. Update the firmware”.
o
The screens used in this example are from Windows 10.
1
Uncompress the downloaded file.
The following files will be created.
o
Win_DFU_driver.exe
o
AP505_updater_xxxx.exe (xxxx is the firmware version)
2
Double-click Win_DFU_driver.exe, and press
the Enter key.
NOTE
If a “User Account Control” pop-up message appears during
installation, click “Yes”.
3
When the Device Driver Installation Wizard
appears, click “Next”.
4
Click “Finish”.
Microsoft and Windows are either registered trademarks or trade-
marks of Microsoft Corporation in the United States and/or other
countries.
Other company names and product names in this document are
the trademarks or registered trademarks of their respective owners.