TEAC AX-501 Owner's Mamual (English, Français, Español) - Page 16

Troubleshooting (2) Specifications There is no sound from one side of the headphones. e Confirm that the headphones plug is inserted completely. Amplifier Maximum output 120 W + 120 W (4 Ω, 1 kHz, JEITA) 70 W + 70 W (8 Ω, 1 kHz, JEITA) Sound output suddenly stopped. e Heat might have caused the protection circuit to activate. Set the POWER switch to OFF once, and wait several minutes before restarting the unit. Rated output 100 W + 100 W (4 Ω, 1 kHz, JEITA) 65 W + 65 W (8 Ω, 1 kHz, JEITA) Compatible speaker impedance range 4 Ω - 8 Ω The level meter lights are blinking and no sound is output. e The + and − speaker cables might have shorted. Turn the unit OFF and check the speaker connections. Total harmonic distortion 0.005% (1 kHz, 8 Ω, 1 W, JEITA) S/N ratio (input short) LINE IN 100 dB (IHF-A) Frequency range 10 Hz - 60 kHz (+1 dB, −5 dB) Automatic power saving caused the unit to enter standby. e Shift the POWER switch to OFF once and then turn the unit back ON. Headphones output Connector Standard 6.3 mm (1/4") stereo jack Maximum output level 50 mW + 50 mW or more (32 Ω, THD+N 0.005%) Since a microcomputer is used in this unit, it might not operate correctly sometimes due to noise and other interference from outside the unit. If this should occur, remove the AC cord from the power socket and wait a while before repowering the unit again. 16