TEAC IF-CB/DM IF-CB:DM Owner's Manual - Page 4
CobraCAD and CobraNet Discovery, Specifications
View all TEAC IF-CB/DM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
IF-CB/DM CobraNet Interface Card DM-4800 OUTPUT SLOT page 1 Use the POD 4 knob to select the output source group from the SOURCE SELECT at the right of the screen. Options for each of the outputs in the output source group selected here are shown the OUTPUT SELECT section on the left of the screen. 2 Use the POD 3 knob to select an IF-CB/DM output channel group (8 channels) to set in the TERMINAL SELECT section in the center of the screen. 3 Use the cursor keys to select an output channel in the OUTPUT SELECT section, and turn the JOG/DATA dial to select its output source. Press the ENTER key to confirm the selection. CobraCAD and CobraNet Discovery CobraCAD is a tool used to design and diagnose network systems. Using a graphic user interface, you can select CobraNet-compatible devices and network devices (such as switching hubs), make connections between devices, set the sampling frequency, latency, bit-rate and other settings, as well as simulate network setups in advance. CobraNet Discovery can be used to list the equipment on the network, view sampling frequency, latency and bit-rate settings, as well as routing information, including transmitter and receiver designations and bundle number settings. A computer running a Windows OS with the CobraNet Discovery software installed on it must be a part of a network in order to create a CobraNet on that network. Installing CobraCAD 1 The latest version of CobraCAD can be downloaded at the following site. http://www.cobranet.info/downloads/cobracad 2 Double-click the downloaded file and follow the instructions shown onscreen to install the software. Using CobraCAD Select Help from the CobraCAD Help menu to open the Help screen. Refer to this for information about how to operate the software. TEAC CORPORATION Phone: +81-42-356-9143 Installing CobraNet Discovery 1 The latest version of CobraNet Discovery Utility can be downloaded at the following site. http://www.cobranet.info/downloads/disco 2 Double-click the downloaded file and follow the instructions shown onscreen to install the software. 3 If the .NET Framework has not been installed on the computer that you are using, during the installation of the CobraNet Discovery Utility, a screen recommending the installation of the .NET Framework should appear. Click "Yes" to install the .NET Framework. After installing the .NET Framework, restart the computer and run the installer for the CobraNet Discovery Utility again. Using CobraNet Discovery To access the CobraNet Discovery User Guide, which explains how to operate the software, follow these instructions. From the Start menu, choose "All Programs" and follow the "CobraNet Discovery" arrow to the following menu. Select "User Guide" to open the CobraNet Discovery User Guide PDF file. Specifications ªªDM-4800/DM-3200 requirements Firmware DM-3200: Version 1.70 or later DM-4800: Version 1.70 or later Note: Use the TMCompanion software to update the firmware of the DM-3200/DM-4800. Mixer slot DM-3200: Use slot 1 DM-4800: Use slot 1 or 3 ªª General Audio inputs: 16 Audio outputs: 16 Quantization bit rate: 16-bit, 20-bit, 24-bit Sampling frequency: 48 kHz PRIMARY and SECONDARY connectors: RJ-45 Compatible cables: Category 5 or higher (straight, shielded, twisted pair) Maximum cable length: 100 m (when using a Category 5 cable) External dimensions: 164 (w) x 40 (h) x 221 (d) mm Weight: 0.3 kg 1-47 Ochiai, Tama-shi, Tokyo 206-8530, Japan Printed in China