Tecumseh Products OVRM120 Operator Manual - Page 12

7. If engine fires but does NOT continue to run, move engine throttle control to "FAST" position and start engine. 8. If engine fails to start after 3 attempts in the "FAST" position, move engine throttle control to "CHOKE" position and start engine. 9. If engine does NOT start after following steps 1 thru 8, contact your Authorized Tecumseh Servicing Dealer. DO NOT attempt to start or troubleshoot this engine in any other way. B. Engine Sections with Recoil Starters Only one of the following three sections will apply to your engine. See Table 4. I. Primer Bulb Only 1. To avoid carbon monoxide poisoning, be sure engine is outdoors in a well-ventilated area. 2. Move engine throttle control to "FAST" position, if present (see equipment manufacturer's instructions). See Figures 21, 22 and 23. Table 4. Engine Sections with Recoil Starters If your engine has: Primer Bulb Only Choke Only Primer Bulb and Choke Go to: Section B.I Section B.II Section B.III 3 2 1 1. Starter Cord Handle 2. Engine Throttle Control 3. Equipment Control Figure 21. Typical Engine Controls Page 10 STOP STOP SLOW RUN FAST CHOKE PRIMER Figure 22. Typical Engine Symbols 4 3 2 1 1. "SLOW" Position 2. "RUN" Range 3. "FAST" Position 4. "CHOKE" Position Figure 23. Start/Choke Control Positions Four-Cycle Engine • Vertical Crankshaft • Air-Cooled 181-1216-14