Thermador HMCN42FS Installation Instructions - Page 9

Installation

Get Thermador HMCN42FS PDF manuals and user guides View all Thermador HMCN42FS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

INSTALLATION Step 5: INSTALLATION This hood is intended to be mounted onto the kitchen wall. 1. Remove the grease filter (refer to Operating Instructions). 2. Draw a line on the wall from the ceiling to the lower edge of the hood at the center of the location where the hood is going to be mounted. 3. Use the template to mark the points on the wall where the screws will be mounted. In order to make it easier to hook the hood onto the screws, draw the outline of the area where the hood will be attached. ṇ CAUTION - Ensure that the minimum distance between the cooktop and the hood is maintained - 30". The bottom edge of the template equates to the lower edge of the hood. 4. Drill 2x 1/4" ø holes for the upper fixing bracket and 2x 1/4" ø holes for the lower fixing bracket and press in wall plugs flush with the wall. Note: At least one screw for the mounting must be installed through a stud. Note: Take into account any special accessories that are going to be fitted. 5. Attach the 2 enclosed spacers to the fixing bracket for the flue duct panelling. Attach the fixing bracket for the chimney panelling using two hexagon head cap screws. 6. Attach the hood. Adjust the height and align horizontally with the adjusting screws. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
9
Step 5: INSTALLATION
This hood is intended to be mounted onto
the kitchen wall.
1.
Remove the grease filter (refer to Opera-
ting Instructions).
2.
Draw a line on the wall from the ceiling to
the lower edge of the hood at the center
of the location where the hood is going
to be mounted.
3.
Use the template to mark the points on
the wall where the screws will be moun-
ted. In order to make it easier to hook
the hood onto the screws, draw the out-
line of the area where the hood will be
attached.
±
CAUTION – Ensure that the minimum
distance between the cooktop and the
hood is maintained – 30”. The bottom edge
of the template equates to the lower edge
of the hood.
4.
Drill 2x
1
/
4
” ø holes for the upper fixing
bracket and
2x
1
/
4
” ø holes for the lower fixing bracket
and press in wall plugs flush with the
wall.
Note:
At least one screw for the mounting
must be installed through a stud.
INSTALLATION
6.
Attach the hood.
Adjust the height and align horizontally
with the adjusting screws.
Note:
Take into account any special
accessories that are going to be fitted.
5.
Attach the 2 enclosed spacers to the
fixing bracket for the flue duct panelling.
Attach the fixing bracket for the
chimney panelling using two hexagon
head cap screws.